Apply SURFANET P.U. single component on dry, non-powdery, dust-free and degreased surface - 200 to 300 gr/m². The preparation might comply with the instructions of the DTU 59.3 and/or 59.1
On a concrete substrate: scrub, repair imperfections if necessary and erase soft roe. Apply a thin primer layer of approx. 100 gr/m² to avoid soft cracks then after 5-6 hours of drying time, apply a second layer on cross way - 100 to 200 gr/m².
Appliance by roller or spray. Drying time: 1 to 2 hours at 20°C.
C haracteristics
Dry film texture /gloss
high gloss or shiny
Density at 20°C
1.00 to 1.10
Viscosity at 20°C
25 to 35 seconds (CF4)
Dry extract (weight/volume)
30 to 70%
Dilution
ready to use / max. 10% with water
Application material
brush, roller
COV*
< 140 g/L
Regulation
2.35 MPA (standard AFNOR NFT 51034)
*values mentionned in EC 1999/13 are sont des calculated theoretical values.
PROPERTIES: fast drying time, perfect adhesion on dry substrate.
Deep abrasion resistance, good water resistance, resistance to alkalines and saline solutions, resistance to oils.
Daily recovering.
P ackaging
5 kg or 20 kg sacks
Storage: 1 year in the original packaging. CAUTION: PROTECT FROM FREEZING
C lassification
NT 36005 – Category I – Class 7B2
R egulation
Toxic free
In the event of splashes on skin, abundantly rinse with clear water
O ther products
LIMITATION OF LIABILITY
The information contained in this leaflet is provided for guidance based on our lnowledge. It does not constitute a waiver of our terms and conditions of sale an shall in no event imply any waranty by us or render us liable with regard to the use of our products.
For each project, a study should be jointly conducted with us.